2027 Denza Z Spider: 1,582 HP, 248-Mile Electric Supercar

The 2027 Denza Z Spider combines a retractable roof with three-motor all-wheel drive, 1,180 kW or 1,582 hp, and 1,240 Nm or 914 lb-ft of torque. Looking at the data, this all-electric high-performance convertible reaches 100 km/h in 2.3 seconds, 200 km/h in 6.46 seconds, and 300 km/h flat out.

Image

The Denza Z Spider carries substantial mass. It weighs 2,300 kg, yet it trails the lighter Coupe by only 0.05 second from zero to 100 km/h. Denza Z uses independent rear motors to control each wheel's torque directly, which improves launch traction and corner-exit response.

Denza Z Spider Dimensions and Specifications

Its 1,975 mm width and 1,350 mm height create a broad, low stance that supports high-speed stability. In addition, the 2,780 mm wheelbase provides enough cabin length for four seats rather than limiting the Spider to two occupants.

Image

Why Three Electric Motors Change the Driving Experience

Denza's e3 Sports Car Platform assigns one motor to the front axle and one motor to each rear wheel. Specifically, this layout lets the control software alter rear-wheel torque without relying on a mechanical differential.

• Front motor: 500 kW and 440 Nm
• Each rear motor: 340 kW and 410 Nm
• Combined output: 1,180 kW and 1,240 Nm
• Motor speed: Up to 30,000 rpm
• Boost mode: 30 percent additional throttle torque for 20 seconds

Vehicle Motion Control coordinates propulsion, brakes, steer-by-wire hardware, and suspension responses in as little as 10 milliseconds. Consequently, the system can correct wheel slip, yaw, or a sudden tire-pressure loss much faster than a conventional mechanical layout.

Image

From an expert perspective, the Spider's DiSus-M magnetorheological dampers deserve equal attention. Denza combines them with air springs, double-wishbone front suspension, and a five-link rear axle. Six-piston front calipers, four-piston rear calipers, and carbon-ceramic discs handle repeated high-speed stops.